Focke 350 S Adhesive Applier For Packing Machines

Glue Applicator / Glue Gun is a component assembled in both cigarette makers and packers, applying glue to different paper materials.

Ferric Oxide For

HMAs do not lose thickness during solidifying; solvent-based adhesives may lose up to 50–70% of layer thickness during drying.

hot melt adhesives provide several advantages over solvent-based adhesives. Volatile organic compounds are reduced or eliminated, and the drying or curing step is eliminated. Hot melt adhesives have long shelf life and usually can be disposed of without special precautions. Some of the disadvantages involve thermal load of the substrate, limiting use to substrates not sensitive to higher temperatures, and loss of bond strength at higher temperatures, up to complete melting of the adhesive. This can be reduced by using a reactive adhesive that after solidifying undergoes further curing e.g., by moisture (e.g., reactive urethanes and silicones), or is cured by ultraviolet radiation. Some HMAs may not be resistant to chemical attacks and weathering. 

Hot Melt Glue

Some polymers can form hydrogen bonds between their chains, forming pseudo-cross-links which strengthen the polymer

Hot melt glues usually consist of one base material with various additives. The composition is usually formulated to have a glass transition temperature (onset of brittleness) below the lowest service temperature and a suitably high melt temperature as well. The degree of crystallization should be as high as possible but within limits of allowed shrinkage. The melt viscosity and the crystallization rate (and corresponding open time) can be tailored for the application. Faster crystallization rate usually implies higher bond strength. To reach the properties of semicrystalline polymers, amorphous polymers would require molecular weights too high and, therefore, unreasonably high melt viscosity; the use of amorphous polymers in hot melt adhesives is usually only as modifiers. 

 Martensitic Steels

Martensitic stainless steels ranges from a large variety of properties and are used as stainless engineering steels, stainless tool steels, and creep-resistant steels. They are all magnetic, but not as corrosion-resistant as ferritic and austenitic stainless steels because of their low chromium content.

They all fall into four categories (with some overlap though)